Right Or Left Facing Hanger | BCC03RL

Adjustable pivot point allows you to customize each space according to your desired look or need. Adjust the direction the instrument faces as well as the space between instruments to maximize your space. The pivoting, padded, adjustable cradle allows for the guitar’s headstock to be cradled perfectly while still hanging straight. Arm length 7 inches Swing arm length 2 inches; Cradle attaches to the end of the swing arm Made in the USA and backed by a lifetime structural warranty Mounting Hardware Included (flat wall installation) Slatwall Clip included (slatwall installation) This clip prevents the hanger from lifting off of your slatwall when the instrument is removed Questions about nitrocellulose? See our statement here. Spacing Spacing is dependent on the angle the arm is set and the thickness of the instrument resting in the hanger Installation Instructions: Flat Wall: Choose location for hanger.  Drive screws through mounting holes of hanger into wall using a phillips screwdriver.  If a wall stud is not found, these pilot holes are necessary for installing the plastic toggles.  To do this, use the screwdriver to push and turn the toggle clockwise until flush.  Remount hanger with screw into toggles.  DO NOT REUSE TOGGLES. Slatwall: Hook the clip into your slatwall system, just to the left of the hanger.  Then, gently pull the lip open on the right edge of the clip, and slide it over the hanger plate. Make sure that the lip has locked in place securely around the right edge of the plate. (This clip allows for movement of the plate, without allowing it to lift off your slatwall when the instrument is removed.)